经典案例

联系方式

公司名称:昆山华航电子有限公司
公司电话:0512-50139595
公司邮箱:eric@kshuahang.com
公司地址:江苏省昆山市善浦西路

您当前的位置:首页 > 技术资源 > 芯片解密

解密案例:AT91SAM7S128解密――ATMEL单片机解密

        近年来,深圳wy解密研究所依托深圳本地良好的技术研发环境,不仅在疑难解密领域倾注更多的研发资源,同时也在普通单片机低成本解密方案研究领域加大了投入,在技术攻关中成功研究出了EMC单片机、HOTEK单片机、CYPRESS单片机、MXIC单片机等单片机类型的超低成本解密方案,对其中的部分芯片几乎可实现零成本解密,如EMC系列的EM78P153(E) 、EM78P156(E) 、EPM78P447、EM78P451/458/459 ,HOTEK系列的HT46RXX 、HT48RXX 、HT46CXX、HT48CXX,MXIC系列的MX10FLCDPC、MX10FMAXPC 、MX10MAXDQC、MX10E8050I等等,为芯片解密行业的整体发展以及民族产业振兴、世界电子产业的快速进步作出了突出贡献。
        有AT91SAM7S128解密需求者请直接与我们联系。

  TheAT91SAM7S128 is a low pincount Flash microcontroller based on the 32-bit ARM7TDMI RISC processor. It features 128K bytes of embedded high-speed Flash with sector lock capabilities and a security bit, and 32K bytes of SRAM. The integrated proprietary SAM-BA Boot Assistant enables in-system programming of the embedded Flash. Its extensive peripheral set includes a USB 2.0 Full Speed Device Port, USARTs, SPI, SSC, TWI and an 8-channel 10-bit ADC. Its Peripheral DMA Controller channels eliminate processor bottlenecks during peripheral-to-memory transfers. Its System Controller manages interrupts, clocks, power, time, debug and reset, significantly reducing the external chip count and minimizing power consumption. In industrial temperature, worse case conditions the maximum clock frequency is 55MHz. Typical core supply is 1.8V, I/Os are supplied at 1.8V or 3.3V and are 5V tolerant. An integrated Voltage Regulator permits single supply at 3.3V. The AT91SAM7S128is supplied in a 64-lead LQFP or QFN Green package. It is supported by an Evaluation Board and extensive application development tools. TheAT91SAM7S128 is a general-purpose microcontroller, providing an ideal migration path for 8-bit applications requiring additional performance, USB connectivity and extended memory.
  AT91SAM7S128 特性
  Incorporates the ARM7TDMI? ARM? Thumb? Processor
   High-performance 32-bit RISC Architecture
   High-density 16-bit Instruction Set
   Leader in MIPS/Watt
   EmbeddedICE? In-circuit Emulation, Debug Communication Channel Support
  Internal High-speed Flash
   512 Kbytes (AT91SAM7S512) Organized in Two Contiguous Banks of 1024 Pages
  of 256 Bytes (Dual Plane)
   256 kbytes(AT91SAM7S256) Organized in 1024 Pages of 256 Bytes (Single Plane)
   128 Kbytes (AT91SAM7S128) Organized in 512 Pages of 256 Bytes (Single Plane)
   64 Kbytes (AT91SAM7S64) Organized in 512 Pages of 128 Bytes (Single Plane)
   32 Kbytes (AT91SAM7S321/32) Organized in 256 Pages of 128 Bytes (Single Plane)
   Single Cycle Access at Up to 30 MHz in Worst Case Conditions
   Prefetch Buffer Optimizing Thumb Instruction Execution at Maximum Speed
   Page Programming Time: 6 ms, Including Page Auto-erase, Full Erase Time: 15 ms
   10,000 Write Cycles, 10-year Data Retention Capability, Sector Lock Capabilities,
  Flash Security Bit
   Fast Flash Programming Interface for High Volume Production
  Internal High-speed SRAM, Single-cycle Access at Maximum Speed
   64 kbytes (AT91SAM7S512/256)
   32 kbytes (AT91SAM7S128)
   16 kbytes (AT91SAM7S64)
   8 kbytes (AT91SAM7S321/32)
  Memory Controller (MC)
   Embedded Flash Controller, Abort Status and Misalignment Detection
  Reset Controller (RSTC)
   Based on Power-on Reset and Low-power Factory-calibrated Brown-out Detector
   Provides External Reset Signal Shaping and Reset Source Status
  Clock Generator (CKGR)
   Low-power RC Oscillator, 3 to 20 MHz On-chip Oscillator and one PLL
  Power Management Controller (PMC)
   Software Power Optimization Capabilities, Including Slow Clock Mode (Down to
  500 Hz) and Idle Mode
   Three Programmable External Clock Signals
  Advanced Interrupt Controller (AIC)
   Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
   Two (AT91SAM7S512/256/128/64/321) or One (AT91SAM7S32) External Interrupt
  Source(s) and One Fast Interrupt Source, Spurious Interrupt Protected
  Debug Unit (DBGU)
   2-wire UART and Support for Debug Communication Channel interrupt,
  Programmable ICE Access Prevention
  Periodic Interval Timer (PIT)
   20-bit Programmable Counter plus 12-bit Interval Counter
  Windowed Watchdog (WDT)
   12-bit key-protected Programmable Counter
   Provides Reset or Interrupt Signals to the System
   Counter May Be Stopped While the Processor is in Debug State or in Idle Mode
  Real-time Timer (RTT)
   32-bit Free-running Counter with Alarm
   Runs Off the Internal RC Oscillator
  One Parallel Input/Output Controller (PIOA)
   Thirty-two (AT91SAM7S512/256/128/64/321) or twenty-one (AT91SAM7S32) Programmable I/O Lines Multiplexed with up
  to Two Peripheral I/Os
   Input Change Interrupt Capability on Each I/O Line
   Individually Programmable Open-drain, Pull-up resistor and Synchronous Output
  Eleven (AT91SAM7S512/256/128/64/321) or Nine (AT91SAM7S32) Peripheral DMA Controller (PDC) Channels
  One USB 2.0 Full Speed (12 Mbits per Second) Device Port (Except for the AT91SAM7S32).
   On-chip Transceiver, 328-byte Configurable Integrated FIFOs
  One Synchronous Serial Controller (SSC)
   Independent Clock and Frame Sync Signals for Each Receiver and Transmitter
   I?S Analog Interface Support, Time Division Multiplex Support
   High-speed Continuous Data Stream Capabilities with 32-bit Data Transfer
  Two (AT91SAM7S512/256/128/64/321) or One (AT91SAM7S32) Universal Synchronous/Asynchronous Receiver Transmitters
  (USART)
   Individual Baud Rate Generator, IrDA? Infrared Modulation/Demodulation
   Support for ISO7816 T0/T1 Smart Card, Hardware Handshaking, RS485 Support
   Full Modem Line Support on USART1 (AT91SAM7S512/256/128/64/321)
  One Master/Slave Serial Peripheral Interface (SPI)
   8- to 16-bit Programmable Data Length, Four External Peripheral Chip Selects
  One Three (AT91SAM7S512/256/128/64/321)-channel or Two (AT91SAM7S32)-channel 16-bit Timer/Counter (TC)
   Three (AT91SAM7S512/256/128/64/321) or One (AT91SAM7S32) External Clock Input(s), Two Multi-purpose I/O Pins per
  Channel
   Double PWM Generation, Capture/Waveform Mode, Up/Down Capability
  One Four-channel 16-bit PWM Controller (PWMC)
  One Two-wire Interface (TWI)
   Master Mode Support Only, All Two-wire Atmel EEPROMs Supported
  One 8-channel 10-bit Analog-to-Digital Converter, Four Channels Multiplexed with Digital I/Os
  SAM-BA? Boot Assistant
   Default Boot program
   Interface with SAM-BA Graphic User Interface
  IEEE? 1149.1 JTAG Boundary Scan on All Digital Pins
  5V-tolerant I/Os, including Four High-current Drive I/O lines, Up to 16 mA Each
  Power Supplies
   Embedded 1.8V Regulator, Drawing up to 100 mA for the Core and External Components
   3.3V or 1.8V VDDIO I/O Lines Power Supply, Independent 3.3V VDDFLASH Flash Power Supply
   1.8V VDDCORE Core Power Supply with Brown-out Detector
  Fully Static Operation: Up to 55 MHz at 1.65V and 85°C Worst Case Conditions
  Available in 64-lead LQFP Green or 64-pad QFN Green Package (AT91SAM7S512/256/128/64/321) and 48-lead LQFP Green or
  48-pad QFN Green Package (AT91SAM7S32)


上一篇:详解微控制器单片机(MCU)
下一篇AT89C51CC03C破解
温馨提示:
凡在本公司进行电路板克隆业务的客户,必须有合法的PCB设计版权来源声明,以保护原创PCB设计版权所有者的合法权益;
【 字体: 】【打印此页】 【返回】【顶部】【关闭